An ILCE-7RM6 ARW with Sony's distortion table now imports with Enable
Lens Corrections on: Photo::camera_defaults already turns the correction
on for any file whose probe yields embedded lens data, and the ARW
decoder emits it since the previous commit. No new default rule is
needed, so RW2 and DNG keep theirs (on when the file carries a
correction) and stored settings are never rewritten.
Tests pin it: a synthetic ARW imports with the correction on (another
body's tables are not read: off), RW2 / DNG defaults are unchanged, and
an ARW catalogued without lens data or switched off by the user keeps
its settings across a library reopen. The Optics panel's hint drops
"(DNG lens opcodes only)" in every locale.
Co-Authored-By: Claude <noreply@anthropic.com>
vendor::arw_lens_rm6::warp_opcode (was distortion_opcode) turns the CA table
(0x7035: red half, blue half, on the distortion knots) into the R and B
planes of the WarpRectilinear: a colour's source radius is
g (1 + c(g) / 3.36e6) at the green source radius g. The unit is provisional
(borderline measurement, about +-30 % scene bias). Each colour plane goes
through the same fit gate as G, and a table with a value beyond 2e-3 relative
(about 12 px at the full-frame corner; the 54 photos' tables stay below
5.1e-4, i.e. 1724) is refused; without a CA table, or when it is refused, the
warp keeps its single G plane, and CA alone is never applied. fit_radial_warp
now rounds its gate up to the next sample, capped at 1 (a NaN gates every
sample), so the band between the last sample inside the crop and the crop
corner is checked too (RW2 passes 1.0: unchanged).
Co-Authored-By: Claude <noreply@anthropic.com>
New vendor::arw_lens_rm6 reads the raw IFD's lens tables (0x7037 distortion,
0x7032 vignetting, 0x7035 lateral CA, their flags) and turns the distortion
table into a one-plane WarpRectilinear in OpcodeList3, with the conventions
measured on 54 ILCE-7RM6 photos: knots at i/15 of the full-frame crop half
diagonal, S(r) = r (1 + v(r)/15000), frame-filling zoom, centred on the
default crop. Only the ILCE-7RM6 is enabled; vignetting is read, not applied.
The radial least-squares fit is split out as vendor::fit_radial_warp (RW2
results unchanged); its error gate can be limited to the radii the crop
shows, so a padded active area (lossless files) doesn't refuse a fit over
pixels that are never rendered.
It sits next to main's vendor::arw_lens (#498), which holds the ILCE-7RM4A
conventions measured against Sony's exports (unit 16384, table indexed at the
output radius); the two are selected by camera model (disjoint allowlists).
arw::decode chains this module's opcodes after arw_lens::distortion, with the
same active area and the same crop (the DNG-style default crop when the file
has one, which on the ILCE-7RM6 equals Sony's crop tags), and like it only
for CFA data (not the downsized linear-RGB lossless sizes, where the knot
spacing in full-frame pixels would not hold).
The corpus test checks the conversion on the two lossless RawDB files (CC0).
The APS-C one is pinned in xtask RAW_SAMPLES with its sha256; the full-frame
one is not (at most two pins per PR, and #625 pins two Compressed ARW 6.0
files), so its case runs only where the file is present.
RENDER_CACHE_VERSION 62 -> 63.
Co-Authored-By: Claude <noreply@anthropic.com>
Move the forward-map inversion, least-squares fit and solve4 out of the RW2
decoder into vendor::warp_from_forward_map; RW2 calls it in DNG-normalised units.
Co-Authored-By: Claude <noreply@anthropic.com>
