Create: Strokes drew every line with round caps: a square-ended line 10 px wide
had its corners 2.94 px outside the stroke.
- A line's ends are square when its ink reaches as far a third of the width to
either side of its middle as along it (a round end stops short there by a
seventh of the width); told from lines 3 px wide and more, all the ends of a
line together. The stroke then has square caps (`TracedPath::square_caps`).
- The last points of a wide line's skeleton can turn towards a corner of its
end. An end that has left the line the skeleton followed a width back (by a
quarter of the width, 1 px at least) is put back on it; and an end may be
pulled back as well as pushed out to where the ink ends.
Outline on the thin-line inputs: largest distance from the art 2.94 -> 0.88 px
(clean 2.94 -> 0.41; aliased 0.88 -> 0.81), mean 0.055 -> 0.050 px, anchors
14 -> 10.
Create: Strokes (the Outline preset, or the option) traced lines along the pixel skeleton: right to a pixel,
with a width counted in pixels, and fitted by a separate, older fitter.
- Each skeleton point is moved to the middle of the line's ink, read from the image across the line: every
pixel counts as much ink as its colour is the line's rather than the paper's, the ink's centroid is the
middle and its sum the width (an anti-aliased or blurred line says both to a fraction of a pixel).
- The stroke width is the median of those widths, no longer a whole number of pixels.
- Each end goes where the ink ends, less the half width a round cap adds.
- Centre lines are fitted as outlines are: a straight line is two anchors, corners stay corners, Snap Curves To
Lines levels them. The old Douglas-Peucker and simplify fitter, and the crate's pathops dependency, go.
Outline on the thin-line inputs, all sizes and variants (docs/image-trace-quality.md), before -> after:
- painted outline 0.310 -> 0.055 px off on average; 81 -> 14 anchors for five lines
- centre line 0.295 -> 0.052 px from the true centre line; stroke width 0.13 -> 0.02 px off; 18.4 -> 2.7
anchors a stroke (blurred, noisy and scanned lines: 2.0 each; aliased: 4.6)
- largest distance 1.84 -> 2.94 px: the square ends of a 10 px line under a round cap
Presets without Create: Strokes are unchanged.
Advanced › Create: Fills and/or Strokes, with Stroke (the widest line, px).
With Strokes, each colour's 8-connected parts no wider than the stroke width
(chamfer distance transform) trace as open centre lines instead of filled
outlines: the line is thinned to one pixel (Zhang-Suen with each removal
re-checked, so two-pixel lines survive; staircase corners dropped), its
skeleton becomes runs between ends and junctions (junction pixels merged,
spurs pruned, runs through two-way junctions joined, rings closed), and each
run is simplified and fitted with curves. The stroke width is the line's mean
width (pixels over length). Traced lines get round caps and joins in the
document. Without Fills, wider areas become 1 px stroked outlines.
`imageTrace.make` takes fills, strokes and strokeWidth, and refuses neither
fills nor strokes and a non-positive width.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
bflatastic