* AutoCAD interop: justified text, DIMPOST, current dimension style, *D block colours
What AutoCAD takes from CADCraft's DWG/DXF as it is:
- Justified TEXT/ATTRIB/ATTDEF (#1050): group 10 is now where the
baseline starts, from the alignment point and the text's width, not
the alignment point itself; AutoCAD drew centred and right-aligned
text from DWG starting at its alignment point. A stored point close to
CADCraft's own (AutoCAD's, exact for its fonts) is kept.
- DIMPOST (#1053) is written even when empty: the DWG bridge defaulted a
missing one to "<>", and AutoCAD then dropped the "R" of radius
dimensions when it regenerated them.
- The current dimension style (#1051): the DXF header now carries its
DIM* variables (AutoCAD draws new and updated dimensions from them);
the DWG bridge points $DIMSTYLE at the style by name (its handle was
renumbered, so the writer fell back to Standard), and reading a DWG
gives the current dimension and text styles their names back.
- *D blocks (#1052): lines, arrows, extension lines and text take the
style's DIMCLRD/DIMCLRE/DIMCLRT instead of ByBlock.
#1054 (group 42 of a rotated linear dimension) was already fixed on
main by #855; acad_interop.rs keeps it covered.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
* Test: angular dimensions store their angle in radians (group 42)
Three-point (60°, 174°) and two-line (120°) angular dimensions, read back
from the DWG as DXF. Already right on main since #855; this guards it.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
* Justified text made here: Left Middle and Left Bottom write their baseline start too
text_insert kept a stored insertion point that was within 0.1 x an
estimated width + 0.5 x height of CADCraft's baseline start, taking it for
AutoCAD's own. The width was estimated from the alignment point's offset,
which for Left Middle is only h/2 (vertical), so a text made here, whose
stored point is the alignment point, passed and kept it: AutoCAD drew it
half a height high (Left Bottom: a third). Reported with a test by
@lee-cyrille-maskell.
A stored point equal to the alignment point is now always stale. Otherwise
the offset is split along and across the baseline: along it the same slack
as before (a tenth of the text's width plus half its height, as fonts and
their substitutes differ most in width), across it a fifth of the height.
Multiline attribute values keep the distance-only check, since their lines
are placed by the embedded MTEXT.
On 12 drawings made in AutoCAD (1,055 justified texts) the insertion points
written are the same as before.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
---------
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
