TEXTEDIT's prompt no longer reads "or or". Undo reverts the last edit made
in this TEXTEDIT, and Mode switches between Multiple (keep selecting) and
Single (end after one edit). At the command line and in scripts, MTEXT
takes one paragraph per input line until an empty line, instead of ending
after the first line and running the next one as a command. The Text
Editor window sends its contents and then Enter, so it still ends MTEXT.
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
AREA's Object option measures picked objects; Add area / Subtract area keep
a running "Total area" over areas measured by points or by object, and
Enter at the first-corner prompt ends the command. Length continues the
last segment by a typed length in AREA and DIST point sequences. DIST's
Multiple points measures a path and reports the running and total
distance. Arc now says it is not available yet instead of being ignored
(or ending AREA as Total).
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
"Specify the reference angle <0>" takes a typed angle or two points;
"Specify the new angle or [Points] <0>" takes a typed angle, a point
measured from the base point, or two points after `P`. The objects turn by
the new angle minus the reference angle. Previously Reference only said
"not available yet" and the values that followed were misread or run as
commands.
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
ELLIPSE: after Rotation the next value is the rotation around the major
axis (ratio = cos angle, 0 to 89.4 degrees; a picked point gives the
angle from the centre), instead of the other-axis distance. At the
elliptical arc's start/end prompts, Parameter reads the values as
ellipse parameters and Angle switches back to true angles.
BREAK: First point asks for a new first break point; the selection pick
then only selects the object.
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
Raster images: the reader now follows an IMAGE's group 340 to its IMAGEDEF
and keeps the file path and the definition's name (its ACAD_IMAGE_DICT
key), pixel size and resolution unit. It also keeps the clip boundary (in
pixel coordinates), the clipping state, the display flags and
brightness/contrast/fade. The writer emits the IMAGE entity, plus one
IMAGEDEF per path and name, an IMAGEDEF_REACTOR per image,
RASTERVARIABLES, the ACAD_IMAGE_DICT and ACAD_IMAGE_VARS entries in the
named object dictionary, and the four CLASS records, as the DXF Reference
describes. An image without a clip boundary gets the full-image rectangle.
DWG save keeps the same data, except the resolution unit, which the DWG
bridge drops. The pixels are still not loaded.
Entity types CADCraft doesn't model (MLINE, MULTILEADER, 3DSOLID, REGION,
MESH, ...) are still not written. Writing their raw groups back into the
R2000 file would leave references to objects that aren't kept
(MLINESTYLE, MLEADERSTYLE, ACIS data in later versions), and some of the
types don't exist in R2000 at all. Another CAD program could then reject
the whole file. Instead, qsave, saveas and document.bytes now say on the
command line which ones weren't saved ("Not saved (CADCraft can't write
these object types yet): 1 3DSOLID, 2 MLINE") and list them by type in the
result's `notSaved`. `cadcraft-cli run --save` and `convert` print the
same line.
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
